When this D8T LGP Dozer arrived in yard, MEL had local CAT dealer complete the following:

• Strip machine for power washing
• Complete CAT TA1 Plus inspection
• Update ECM flash files
• Cut open all filters & inspect for contaminates - all clean
• Service emissions system if needed
• Inspect magnetic plugs/screens & suction screens - all clean
• Replaced all machine component breathers
• Serviced engine
• Check oil levels
• Inspect oils for discoloration
• Check for logged & active codes & repair
• Check for applicable service letters
• Changed engine, final drive, transmission & hydraulic oils

Completed the following Pressure / Performance checks to ensure within OEM spec:

• Fan pressure & speed
• Engine RPM high & low idle
• Engine oil high & low idle pressures
• Fuel pressure
• Torque convertor stall speed
• Full stall boost 
• Implement standby pressure
• Transmission pump pressure
• Torque inlet/outlet pressures
• Torque convertor lock-up clutch
• Flywheel low pressure - high/low
• Transmission lube pressure - high/low
• Performed clutch fill calibration
• Steering system charge pressure
• Brake pressure

Based on inspection, CAT mechanic completed the following repairs:

• Installed New Def tank filter
• Installed NEW DEF injector
• Installed NEW ARD Head and spark plug
• Installed NEW pivot shaft oil reservoir bottle
• Replaced Thermostats
• Resealed thermostat housing and replaced hoses to housing
• Installed New Rad Cap
• Completed all needed Electrical Repairs
• Resealed Engine Oil pan
• Inspected Engine Oil pump and Resealed
• Replaced rear engine mounts
• Replaced starter with rebuilt unit
• Resealed Transmission Pump
• Rebuilt Implement Pump
• Resealed all Accessory Drive covers on Flywheel housing
• Replaced All Powertrain, Steering, Brake and Implement Hoses
• Repaired All Leaks
• Replaced All Pivot Shaft oil lines and Resealed all fittings
• Replaced Upper and Lower Coolant Hoses
• Replaced All Heater hoses to cab
• Replaced A/C Drier, Acumulator
• Replaced several A/C related hoses
• Cleaned HVAC system - All New hoses installed
• A/C was Vac Checked, Charged to Spec and Operates as it should
• Completed engine valve & injector set
• Replaced Cab Mounts

Marcel Equipment completed the following repairs:

• Replaced Lift Cylinder Yoke Bearings
• Resealed Lift Cylinders
• Rebuilt Equalizer Bar Assembly
• Rebuilt Seat Assembly
• Completed required cosmetic & welding repairs
• Completed required blade repairs
• Replaced required blade pins & bushings
• Line bored blade joints where required
• Prepped machine for sandblasting & painting
• Sandblasted, primed, painted & detailed
• Assembled machine once completed
• Greased machine

This CAT D8T Tractor is now ready for work.

The following are repairs completed by the CAT dealer prior to Marcel Equipment owning this CAT D8T LGP Bulldozer​:

At 13,956 hours, installed NEW a/c compressor. 

At 13,816 hours, removed & cleaned DPF filter 

At 13,816 hours, installed NEW engine oil cooler 

At 13,759 hours, installed NEW HVAC blower motor 

At 13,432 hours, installed NEW alternator  

At 12,425 hours, installed NEW radiator 

At 10,253 hours, installed REMAN DPF assembly w/ NEW DEF injector & filter

At 6,355 hours, installed REMAN ARD head 

At 3,625 hours, installed NEW updated DEF pump under service letter