When unit arrived in yard, MEL had local CAT dealer complete the following:

• Strip machine for power washing
• CAT TA inspection
• Update ECM flash files
• Cut open all filters & inspect for contaminates - all clean
• Service engine
• Inspect magnetic plugs/screens & suction screens- all clean
• Check oil levels
• Inspect oils for discolouration
• Check for logged & active codes & repair

Completed the following pressure checks to ensure within OEM spec:

• Engine rpm high & low idle
• Engine oil high & low idle pressures
• Fuel pressure
• Full stall boost 
• Full stall speed
• Transmission pump pressure
• Transmission lube pressure
• Steering pressure check
• Steering high pressure cut-off
• Hoist relief pressure
• Brake cut-in/cut-out pressure

Based on inspection, MEL completed the following repairs:

• Installed NEW front brake pads & rotors
• Installed NEW duo cone seal on front left wheel hub
• REBUILT right rear brakes w/ all NEW plates & friction discs
• Left rear brakes removed, cleaned, inspected & resealed
• Installed NEW duo cone seal on rear wheel ends
• Replaced all required brake hoses/lines
• Installed NEW pins & bearings on rear suspension cylinders
• Right rear suspension sensor broken – replaced sensor
• Installed NEW transmission output shaft seal
• Transmission filler joint coupler leaking – replaced coupling
• Installed NEW oil drain line on turbo
• Serviced DPF- field cleaned
• Serviced emission system w/ NEW filter, DEF injector & spark plug
• Replaced all required w/ NEW coolant lines 
• Installed NEW a/c compressor, accumulator & dryer
• Replaced required hydraulic lines
• Replaced required powertrain lines
• Line bored rear box mount bores
• Installed NEW box mount pins & bearings
• Steering cylinders have play at barrel end - installed NEW tie rods
• Line bored rear axle A-frame bore
• Installed NEW pin & bearing in A-frame
• Installed NEW pins & bearings in rear axle stay arm
• Completed required cosmetic & welding repairs
• Box bed was inspected & repaired as needed

Machine is ready to go to work.