The following Repairs were completed by Marcel Equipment at 8070 Hrs:

• Upon arrival to our yard, machine was stripped for power washing
• Machine was inspected visually & operationally
• Engine oil filter was cut open - clean
• Transmission filter was cut open - clean
• Hydraulic filter was cut open - clean
• Magnets & suction screens checked - clean
• Final drive oils were checked - levels good & oil clean
• Engine, transmission, hydraulic & final drive oils changed

The following pressures were taken to ensure within OEM spec:

• Engine high/low RPM
• Engine oil pressure - high/low
• Fuel pressure - high/low 
• Engine boost 
• Transmission pump pressure - high/low
• Transmission lube pressure - high/low
• Torque converter inlet & outlet
• Pilot pressure
• Main relief pressure
• Brake pressure
• Fan speed - max/min

The following repairs were completed by Marcel Equipment as a Result of our Inspection:

• Resealed tilt cylinder & installed NEW pins & bushings
• Resealed both blade lift cylinders
• Installed NEW blade yoke mounting bushings
• Resealed start motor
• REBUILT & resealed transmission pump
• REBUILT equalizer bar w/ new pins & bushings
• Line bored equalizer bar machine center bores
• Installed NEW pins & bushings in hardnose assembly
• RESEALED left & right final drives
• RESEALED engine oil pan
• Sent out rad for cleaning & testing
• Installed NEW track pads on chains
• Installed NEW DEF manifold
• Installed NEW a/c compressor lines & dryer
• Installed NEW DEF heater lines from pump to tank
• Installed NEW DEF return line from pump to tank
• Replaced required hoses/lines throughout machine
• Installed NEW armrests
• Installed NEW engine belt
• Replaced required trim pieces in cab
• Installed NEW seat belt
• Repaired all lights as required
• Installed NEW washer pumps
• Installed NEW hydraulic lock-out switch
• Installed NEW heater core valves & actuator
• Resealed auxiliary drive cover
• Replaced required coolant lines
• Repaired EGR valve & replaced sensors
• Inspected & serviced electrical breaker box
• Tested batteries & serviced connections
• Completed required cab repairs
• Completed MISC repairs on machine
• Completed required cosmetic & welding repairs
• Completed required welding repairs on blade
• Greased machine
• Machine was sand blasted, primed & painted

Machine is Completed and work ready.

The following are repairs completed by the CAT Dealer prior to Marcel Equipment owning this D6T XW WH Dozer:

At 7,750 hours, REBUILT transmission 

At 7,750 hours, REBUILT torque converter 

At 7,750 hours, installed NEW transmission cooler 

At 7,750 hours, installed NEW fuse box wiring harness 

At 7,750 hours, installed NEW boost solenoid

At 7,044 hours, installed NEW alternator

At 5,395 hours, installed NEW monitor & updated software

At 4,756 hours, installed NEW main power relay

At 4,744 hours, completed 5,000 hour emission service:

• NEW DPF
• NEW DEF manifold
• NEW DEF injector
• NEW DEF filter
• NEW spark plug

At 4,655 hours, the following u/c work was completed:

• Rebearing & reseal front roller frames
• NEW track chains
• NEW sprocket segments
• NEW idlers
• NEW carrier rollers
• NEW bottom rollers
• Resealed pivot shafts
• Resealed track adjusters
• Rebearing & reseal equalizer bar w/ NEW pins

At 4,328 hours, installed NEW NOX sensors

At 3,755 hours, installed NEW ARD fuel pump

At 2,312 hours, installed NEW starter