At 4,995 hours, completed 5,000 hour emission service

When this Wheel Loader arrived in yard, MEL had local CAT dealer complete the following:

• Strip machine for power washing
• CAT TA inspection
• Cut open all filters & inspect for contaminates - all clean
• Service engine
• Inspect magnetic plugs/screens & suction screens
• Check oil levels
• Inspect oils for discolouration
• Check for logged & active codes & repair
• Update ECM flash files

Completed the following pressure checks to ensure within OEM spec:

• Engine high & low idle
• Engine high & low oil
• Fuel high & low idle
• Boost 
• DPF differential 
• Pilot 
• Main relief 
• Implement standby 
• Steering pump standby 
• Brake charge 
• Service & park brake tests
• Pilot accumulator test

Based on inspection, CAT mechanic completed the following repairs on this CAT 988K:

• Resealed engine oil pan
• Resealed right hand starter
• Serviced the emission system as needed
• Repaired leaking transmission relief valve
• Repaired leak from thermostat elbow
• Replaced ECM coolant lines
• Serviced battery connections

The following repairs were completed by Marcel Equipment on this CAT 988K:

• Completed our own visual & operational inspections
• Replaced wiper knobs
• Replace 2 plastic console pieces in cab
• Repaired steering control
• Replaced plastic pieces around steering control
• Replaced EGR water line clamp that was missing
• Replaced 2 clamps on overflow tank line that were missing
• Replaced 2 rear HID lights
• Replaced 2 rear cab work lights
• Installed 3rd function lockout switch
• Cleaned heater box & pre-cleaner
• Replaced washer pumps
• Resealed both steering cylinders
• Resealed right side lift cylinder
• Replaced top rad hoses
• Replaced 2 heater taps
• Replaced block heater
• Completed required cab repairs
• Completed MISC repairs on machine
• Greased machine

Machine is ready to go to work.