When this 938M wheel loader arrived in yard, MEL had local CAT dealer complete the following:
- Strip machine for power washing
- Complete CAT TA1 Plus inspection
- Complete all Pressure & Performance checks to ensure within OEM spec
- Update ECM flash files
- Cut open all filters & inspect for contaminates - all clean
- Service emissions system as needed
- Inspect magnetic plugs/screens & suction screens - all clean
- Replaced all machine component breathers
- Service machine as required
- Check oil levels
- Inspect oils for discoloration- all good
- Check for logged & active codes & repair
- Check for applicable service letters
Based on inspection, CAT mechanic completed the following repairs:
- Installed 2 NEW brake accumulators
- Installed NEW pilot accumulator
- Installed NEW hoses as needed
- REBUILT parking brake assembly
- Installed NEW rear axle trunnion bushings
- Installed NEW throttle pedal
- Installed NEW wiper blades
- Installed NEW rear washer pump
- Installed NEW back-up alarm
- Installed NEW right-side mirror
- Completed required cab repairs
- Serviced breaker panel
- Serviced batteries & connections
- Installed NEW rad cap
- All NEW breathers
Marcel Equipment completed the following repairs:
- Linebored front steering cylinder bores
- Installed NEW pins & bearings in steering cylinders
- Installed NEW washer fluid bottle
- Installed NEW front fenders
- Installed NEW back-up camera
- Installed NEW joystick control
- Installed seat suspension kit
- Ensured all grease points were taking grease
The following are repairs completed by CAT Dealer prior to Marcel Equipment owning the machine:
At 6,152 hours, RESEALED hydrostatic drive pump
At 6,152 hours, RESEALED hydrostatic motors
At 6,152 hours, RESEALED fan motor
At 6,152 hours, REBUILT implement pump
At 6,152 hours RESEALED steering pump
At 4,397 hours, installed CAT REMAN Engine Long Block